Brew Funnels

Coffee Funnels and Fetco Brew Basket for Commercial Coffee and Tea Makers

TEA BREWING
1. Begin each brew cycle with a clean empty brew funnel and server. (Be sure the server lid doesn’t interfere with the flow of dilution water.)
2. Insert a BUNN filter into the funnel.
3. Pour the packet of loose fresh tea leaves into the filter. Approximately three to five ounces is recommended for three gallons of beverage.
4. Level the bed of tea leaves by gently shaking.
5. Slide the funnel into the funnel rails until it stops. On dual dilution models, rotate the funnel handle left or right to align the funnel discharge over the reservoir.
6. The ON/OFF must be ON. Select which batch size to brew.
7. Momentarily press and release the assigned BREW switch. There may be certain situations in which the brew cycle will not begin when BREW is pressed:
a. SWITCH NOT ON - ON/OFF must be ON.
b. BREW TEMPERATURE TOO LOW – wait until heated or cancel BREW LOCKOUT option.
c. CHECK FUNNEL – remove funnel, empty previously brewed leaves and replace with fresh tea leaves.
d. DISABLED - select different brew switch or batch size.
8. If none of the above messages are displayed, the display will read NOW BREWING and show the time remaining in the brew cycle.
9. Following the brew will be a countdown of drip time DRIPPING which shows the time remaining until the tea no longer drips from the funnel tip.
10. Carefully remove the brew funnel and discard the tea leaves and fi lter only after visible dripping stops.

COFFEE BREWING (ITCB/HV ONLY)
WITHOUT A SMART FUNNEL AND G9-2T DBC GRINDER:
1. Begin each brew cycle with a clean empty brew funnel.
2. Insert a BUNN filter into the coffee funnel
3. Pour the fresh coffee into the fi lter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. The ON/OFF must be ON. Select the FULL batch size.
7. Momentarily press and release the assigned BREW switch. There may be certain situations in which the brew cycle will not begin when BREW is pressed:
a. SWITCH NOT ON - ON/OFF must be ON.
b. BREW TEMPERATURE TOO LOW – wait until heated or cancel BREW LOCKOUT option.
c. CHECK FUNNEL – remove funnel, empty previously brewed grounds and replace with fresh.
d. DISABLED - select different brew switch or batch size.
e. COFFEE FUNNEL? – appears when brew volume is greater than 86.0 oz. (2.54 L) and pulse brew is disabled. Check to make sure the correct funnel is in place, and then press BREW again.
8. If none of the above messages are displayed, the display will read NOW BREWING and show the time remaining in the brew cycle.
9. Following the brew will be a countdown of drip time DRIPPING which shows the time remaining until the coffee no longer drips from the funnel tip.
10. Carefully remove the brew funnel and discard the grounds and fi lter only after visible dripping stops.

WITH A SMART FUNNEL AND G9-2T DBC or MHG GRINDER: (ITCB/HV ONLY)
1. Select the small batch size on the grinder.
2. Insert a BUNN fi lter into the funnel.
3. Grind the selected amount of fresh coffee into the Smart Funnel using the G9-2T DBC or MHG with Smart
Funnel operation and level the grounds by gently shaking.

Filter
Set Descending Direction

8 Items

per page
View as Grid List
Filter
Set Descending Direction

8 Items

per page
View as Grid List